There are many ways to install the O-ring. In order to avoid damage to the O-ring during installation, it should be avoided that the O-ring passes through sharp edges or inner holes. When the sliding distance is long, the sealing seat should ensure that the sliding distance is as short as possible during installation, thereby reducing damage to the O-ring.
Before installing, we need to determine a few points.
1. Is the chamfer introduced according to the drawing?
2. Is the inner hole cleaned of burrs, and whether the edge is rounded?
3. Are processing residues removed?
4. Is the thread tip covered?
5. Are seals and components lubricated or greased?
6. Ensure the compatibility between the medium and the elastic material.
When installing by hand, use the correct installation tool to ensure that the O-ring is not deformed and installed in the correct position. Do not overstretch the O-ring.
When installing O-rings that need to go over threads, splines, and keyways, it is very necessary to use a copper core. This core can be made of soft metal or plastic. The key is that there should be no burrs and sharp edges, and no damage to the O-ring. ring.
When the machine is automatically installed, sufficient preparations must be made, and the surface of the O-ring must be lubricated with lubricating oil, in order to reduce installation resistance and facilitate disassembly.
The water plug on the engine is to protect the engine and prevent the engine block from being frozen. It is also divided into stainless steel water plug, brass water plug, molten iron plug, molten steel plug and so on.If you have any questions, you can contact us, we will provide you with professional service and high-quality products.
Dowty Seal taken over by Trelleborg sealing solutions. Bonded Seals are made by Trelleborg in the United Kingdom to the original specification.Dowty seals, also called bonded seals, are a washer kind of seal used to tighten the connection around screws and bolts. They are typically made of both a metal and an elastomer material.
It takes four people to remove and install the transmission. The motor should be frozen for five hours and then one hour of labor should be added to each freeze plug on the back of the motor. It may take you about six hours to complete the project, plus parts and fluids.Check out all the Oil Seal available on NNK Web.
The engine water plug is designed to prevent the engine from freezing and damaging the body. Water plugs can also be called: core plugs / bowl plugs / engine heads / cylinder heads / water plugs / water plugs / water plugs / water plugs
TG4 oil seal is a general improved oil seal. Can replace TC, TB, VB, VC, SB, TC4, DKB and other oil seals. Internal use of three-lip design, good sealing performance. Widely used in gasoline engine crankshafts, diesel engine crankshafts, gearboxes, differentials, shock absorbers, engines, axles and other parts.
The power steering oil seal is used in the automotive power steering system. It is a kind of automotive steering oil seal. There are many types of power steering oil seals. If you need to buy power steering oil seal, or you need to know the price of power steering oil seal, please contact us. We provide you with professional sealing solutions.